Emerson’s Guided Wave Radar Level Transmitter is IEC 61508 Certified

Source: www.gulfoilandgas.com 6/12/2014, Location: North America

Emerson Process Management’s Rosemount® 5300 Guided Wave Radar (GWR) level transmitters are now certified to IEC 61508 for safety instrumented functions up to SIL 3. Companies in the oil and gas production, refining, petrochemical, chemical and power industries can now benefit from the accuracy, reliability and flexibility of the 5300 Series GWR for safety-critical level applications such as overfill prevention and dry pump protection.

The functional safety assessment was performed by the independent global organization exida. It covered SIL 2 rated safety applications in a single configuration, and SIL 3 rated safety applications in redundant mode. The certification means that the Rosemount 5300 GWR is suitable for continuous level measurement in safety instrumented functions up to SIL 3, as defined in IEC 61511 for applications in the process industry.

Traditionally, fixed point-level devices have been used for overfill prevention and dry pump protection. The Rosemount 5300 GWR provides all the benefits of continuous level measurement, including the actual product surface location - confirming that the level sensor is functioning correctly. The high and low level alarms are set up locally or remotely during the installation and configuration process.

Proof testing is required at regular intervals to confirm that the overfill and empty tank protection functions result in the desired system response. These conditions can be simulated either locally using a HART-compliant master, such as a Rosemount Radar Master or a Field Communicator, or remotely using Emerson’s AMS Suite software. By removing the need to perform traditional wet tests, which require the tank to be under- or overfilled, the cost and risks associated with proof-testing are considerably reduced.

The Rosemount 5300 Series is a two-wire GWR for challenging level and interface measurements on liquids, slurries and solids. The Direct Switch Technology (DST) function increases measurement reliability and capability. In addition to improving the signal-to-noise ratio, DST enhances the ability to handle disturbing factors, longer measuring ranges, and lower dielectrics, even with a single probe. Maintenance-free operation improves uptime, and advanced configuration and extensive diagnostic information is available through the RadarMaster and EDDL-based user interface.


Related Categories: Analyzers, Gas  Calibration Equipment  Calibrators, Electronic, Pneumatic  Concentration  Conductivity Meters  Density  Detector, Gas  Dissolved Oxygen meters  Drilling Instruments  Float Switch  Gas meters  General  Indicators and Recorders  Leak Locators  Level meters  Liquid Measurement  Load cells  Monitoring & Control  Mud Control  Mud Logging  pH and REDOX  Pressure gauges/ Transmitters  Radiation Detection  SCADA Systems  Temperature gauges/ Transmitters  Thermocouples  Thermowells  Transducers  Transmitters  Transmitters, Pressure  Turbidity Meters  Viscosity  Weather Station  Weighing Equipment 

Related Articles: Analyzers, Gas  Calibration Equipment  Calibrators, Electronic, Pneumatic  Concentration  Conductivity Meters  Density  Detector, Gas  Dissolved Oxygen meters  Drilling Instruments  Float Switch  Gas meters  General  Indicators and Recorders  Leak Locators  Level meters  Liquid Measurement  Load cells  Monitoring & Control  Mud Control  Mud Logging  pH and REDOX  Pressure gauges/ Transmitters  Radiation Detection  SCADA Systems  Temperature gauges/ Transmitters  Thermocouples  Thermowells  Transducers  Transmitters  Transmitters, Pressure  Viscosity  Weather Station 


Gulf Oil and Gas
Copyright © 2023 ICT All rights reserved. - Terms of Service - Privacy Policy.