Gulf Oil and Gas accountACCOUNT

Romania Well Flow Test Operations Update 2

Source: 6/26/2020, Location: Europe

Key Points: - Workover Rig has been mobilized and rigged up according to schedule.

- Production Equipment is being run into the well with perforation equipment required to initiate well production and flow testing.

- Flow Testing is expected to commence next week.

- Further Operations Updates to be provided following the commencement of flow testing.

ADX Energy Ltd (ADX), is pleased to advise that work over rig mobilisation and set up has been completed at the Iecea Mica-1 (IMIC-1) well site at Iecea Mare Production License onshore Romania. The production equipment required to flow test the well is currently being run into the well together with perforation equipment required to initiate flow from the well. Well flow will be initiated utilising underbalanced perforation to maximise inflow and clean up with a view to maximising well productivity. Production testing will commence following the running of the production string and perforation of the well.

ADX will provide further updates following the commencement of flow testing.

Background Regarding IMIC -1 Drilling Results and Testing Objectives (Refer to ADX Release dated 9/9/2019 and note that ADX is not aware of any information or data that materially effects the original estimates)

The IMIC -1 well encountered gas across three zones with a combined total arithmetic sum for the three zones of 20 BCF 2C contingent resources estimated (refer to table below). The well was suspended for future completion as a producer following testing. Testing has been deferred until down hole well production equipment was manufactured and then further delayed due to border closures caused by the Covid-19 pandemic which have prevented testing operations until now.

Testing will concentrate on the PA IV sand (Pliocene age) which is a proven reservoir and has the greatest upside reserves potential of the 3 hydrocarbon bearing reservoir intervals intersected in the IMIC-1 well (refer to table below). This reservoir unit has a large stratigraphic upside potential which will be further quantified in the near future with the planned high resolution 2D seismic program scheduled for the third quarter of 2020.

The testing program has been designed to determine the production capacity of the well through multiple flow rate measurements and pressure build up response measurements. Produced gas will be sampled to determine the suitability of the IMIC-1 gas composition for commercial sales.

The expectation based on mudlog data and nearby analogues is that a dry gas will be produced which will require minimal processing prior to market delivery. Following the completion of the production testing program the well will be shut in awaiting commercial production at a future time.

Gas Commercialisation Studies
Engineering studies are ongoing to determine the potential viability of two development options including the delivery of sales gas to the grid at the nearby Satchinez-Calacea Gas Plant or alternately the conversion of produced gas to power and the connection to a high voltage power line located approximately 2km from the IMIC-1 location. The production test results will provide important information required for the finalization of feasibility studies.

Gas Resource Assessment
The resource potential of the three gas reservoirs intersected at IMIC -1 will be further assessed utilizing high resolution 2D seismic that will be acquired across IMIC-1 and potential IMIC-2 accumulations. The appraisal seismic is expected to better define the extent of gas zones where ADX has interpreted substantial stratigraphic resource upside (refer to ASX announcement on 9 September 2019). The appraisal seismic will be acquired in conjunction with the planned 3D seismic program during the 3rd quarter of 2020 in close proximity to the IMIC -1 and the IMIC-2 wells.

Asset Ownership Structure
ADX holds a 49% shareholding in Danube Petroleum Limited (Danube). The remaining shareholding in Danube is held by Reabold Resources PLC. Danube via its Romanian subsidiary, ADX Energy Panonia srl, holds:

- a 100% interest in the Parta Exploration license in Romania (including a 100% interest in the Parta Sole Risk Area). Upon completion of a farmin by Tamaska Oil & Gas Limitedís subsidiary Parta Energy, Danube will hold a 50% interest in the Parta Exploration License; and
- a 100% interest in the Iecea Mare Production license in Romania (which hosts the IMIC-1 well and future IMIC-2 well).

Logging, Perforating, Testing >>

Logging, Perforating, Testing News in Romania >>

Romania >>  8/7/2020 - Key Points:
- Services engaged including coiled tubing, nitrogen and testing services to acidise and flow test the IMIC-1 well. Program start da...

Australia >>  8/6/2020 - The ATP 2021 joint venture (Vintage Energy Ltd) 50% and operator, Metgasco Ltd 25% and Bridgeport (Cooper Basin) Pty Ltd 25%) is pleased to advise tha...

Egypt >>  7/28/2020 - Eni (as the Operator of the Block), bp and Total (as Contractor members) have successfully tested the well drilled on the prospect called Bashrush, in...
Vietnam >>  7/27/2020 - Eni announces that its exploration well, Ken Bau-2X, located in Block 114, Song Hong Basin, offshore Vietnam, has confirmed a significant hydrocarbon ...

Romania >>  7/21/2020 - ADX Energy has advised that there has been a delay to ongoing well flow testing programs at the Iecea Mica-1 (IMIC-1) well site at the Iecea Mare Prod...
Kazakhstan >>  7/15/2020 - Tethys Petroleum Limited (TPL) ("Tethys" or the "Company") today provides a corporate update. ...

Romania Oil & Gas 1 >>  2 |

More News

Related Links

Gulf Oil and Gas
Copyright © 2020 Universal Solutions All rights reserved. - Terms of Service - Privacy Policy.